Maxon presented new products as well as ceramic applications and the Wheel Drive at Hannover Messe 2024. The company offers customized drive and control solutions for many applications - including self-driving vehicles (AGVs) and autonomous robots (AMR).
VDWF Annual General Meeting 2024
At the end of April, more than 220 members and partners of the Association of German Tool and Mold Makers (VDWF) gathered for the 31st Annual General Meeting. 57 new members introduced themselves, and Vice President Anton Schweiger and CFO Kathrin Schumacher were unanimously confirmed in their positions.
Current TOP 5
Hardware and software combined
At Hannover Messe 2024, Rittal, Eplan, Cideon and German Edge Cloud demonstrated the opportunities that arise from combining software and hardware solutions - across entire ecosystems.
At the Hannover Messe, Festo presented a portfolio of solutions for the clean and economical dismantling and recycling of used batteries.
Wibu-Systems and Flecs Technologies presented the results of their partnership at the Hannover Messe. At a joint press conference, the creative minds of both companies presented their current developments and strategic plans.
Configuration of linear modules
Two new tools from Schunk enable the validated design and individual configuration of linear modules. The new Schunk Control Center also offers an intuitive user experience.
In order to exploit the full potential of aftermarket activities, the entire product life cycle should be considered. Companies that take the step towards digitalization and consistently promote it in all areas can achieve numerous advantages here - from development to installation and service.
The young company ai-omatic solutions from Hamburg presents a digital maintenance assistant that monitors machines automatically and unattended, detects failures in advance and thus predicts the optimum maintenance time.
With the Electronic-Key-System EKS2, Euchner is launching a new key system onto the market. As a further development of the EKS system, the new generation offers advantages in terms of digital access control and operating mode selection.
Ganter offers a wide range of different load attachment points. Classic and simple attachment points are DIN 580 eyebolts, which are screwed into a thread; DIN 582 ring nuts made of steel or stainless steel are suitable for loads without a thread.
